Search results

with Generic Bayer Species Model and Precipitation Model are no longer included with standard SysCAD 9.3 install. These models are no longer supported and

plant model or even a large whiteside model with recycle streams, there is little point in requiring strict convergence of individual precipitation tanks

Alumina 3 Bayer Species Model Unit Type: Precipitator3 - The first tab page in the access window will have this name. Only visible when Precip.Method =

unit models must be changed to Alumina 3 Bayer Species Model and Precipitation3 models. Please solve and retune models. PGM Variable Name Change - Maximum

Navigation: Models ➔ Alumina Models ➔ Heat of Dissolution of Gibbsite and Boehmite Related Links: Precipitation3, Alumina 3 Bayer Species Model The dissolution

Launder input stream connection added to Flotation Cell model. Build 14611: Fix for Thickener model with makeups that when turned off did not stop the makeup

their own model procedures (MP) to be evaluated as part of some unit models. It is like having a PGM inside a Tank, Tie or Pipe model where the code is

Navigation: Models ➔ Sub-Models ➔ Solid-Liquid Separator Related Links: General Separator, Evaporator The Solid-Liquid Separator sub-model is used in the

Evaporation from precipitation tanks. ; The equation solves combined heat/mass transfer problems for free/forced convection from precipitation tanks, ; typically

automatically calculate the Heat of Reaction (HOR) for the dissolution or precipitation reaction based on the thermodynamic data in the Species database for

project must contain at least one OLI Model Configuration model. We have used two OLI Model Configuration models in this project, one we allow supersaturation

PGM file (Precipitation_PGM) Optional Reactions - The hydrate precipitation and Soda co-precipitation reactions are built into the Precipitation unit, no

the air and also the precipitation rate of sucrose from the film to the crystal. This is all taken into account in the model. The model also has the option

Counter flow tie to model columns and dryers. Topics covered in this document relate to using the Gibbs Free Energy Minimisation Reactor model in SysCAD and

with this model are strongly dependent on impurities concentrations. Temperature and supersaturation also have a strong influence. This model was developed

project: Alumina Precipitation and Classification with PSD. This builds on two older examples: Precipitation Project using Full PSD Precipitation Project using

Evaluation Block, prior to any sub-models being applied After each sub-model has been applied, including after the last sub-model has been applied. The PC (Phase

closed organic loop. (Flowsheet 02 Copper Solvent Extraction) The use of Model Procedures to add extraction based on residence time (Flowsheet 05 Non -

"drive" a plant model around nameplate or design condition by introducing small variations in each of the key parameters. Each time the model is run, the base

Navigation: Models ➔ Potash Models ➔ Potash Species Model ➔ Potash Solubility Related Links: Species Models, Evaluation Blocks, Solubility, Plant Model - Soluble