Search results
Jump to navigation
Jump to search
- 138 to Build 139. A table of the SysCAD 9.3 Build 139 changes at the time of first release are shown below. Please click on the table headings, or use the17 KB (139 words) - 17:48, 2 August 2023
- 'Tube In' will flow straight out of 'Tube Out' with no change in temperature and no evaporation; All streams connected to 'Shell In' will flow straight out21 KB (1,534 words) - 09:40, 20 February 2024
- stand-alone heater, you must control the steam flow by setting the Steam flowrate - Qm_Rqd either through a controller or via the PGM for variable flows. Changing17 KB (1,749 words) - 05:09, 15 April 2024
- SysCAD 137 Model Improvements (section Simple Heater)to Ambient (types 2 and 3) and Fixed Heat Flow. New Static Head Pressure - The static head (height of material above the outlet) and static head pressure10 KB (1,236 words) - 11:49, 20 February 2024
- In' inlet will flow out of the 'Hot Out' outlet with no temperature or phase change All streams connected to the 'Cold In' inlet will flow out of the 'Cold27 KB (1,183 words) - 10:12, 30 April 2024
- Build 22458: Fix for Evaporator with internal Heater where too much steam is supplied to internal heater resulting in an energy imbalance error being reported33 KB (5,180 words) - 11:24, 14 February 2024
- be opened in demonstration mode. Please see Required Add-On column in the tables below for license option required to open and run the example projects.28 KB (161 words) - 06:47, 30 May 2024
- itself to set the required steam flow using the SteamOutDemand function. This simple Boiler model does not include a Heater section. Therefore, there is no15 KB (777 words) - 04:12, 21 February 2024
- required water flowrate (FlowReqd - calculated by SysCAD based on the required temperature change) and use it to set the water flow. If the user does enable16 KB (1,284 words) - 05:30, 7 February 2024
- all non-condensable gases in the steam flow in. The vent flow, concentrated liquor flow and evaporated steam flow are all assumed to be at the same pressure30 KB (3,084 words) - 09:40, 20 February 2024
- feeder flow required maximum to prevent excessive flows. Build 17083: Allow user to specify more than 90 PageLabels in a PGM. Build 17066: For Material Tracking57 KB (9,089 words) - 09:50, 11 March 2024
- Simple Heater - New optional side calculation for required Steam flow to achieve specified temperature. Can be used to quickly workout the steam flow requirements7 KB (848 words) - 12:57, 31 July 2023
- attributable to each source of material. Material Tracking is a Quality, similar to Size Distribution (PSD) and LockUp. New Quality Material Tracking Improved efficiency16 KB (2,427 words) - 10:14, 1 February 2024