Search results

Energy Balance add-on and some require an additional add-on as shown in the table below. Without Heat Calculations being enabled in the project, some of the

'Shell' inlet will flow out of the 'Shell' outlet with no temperature or phase change; All streams connected to the 'Tube' inlet will flow out of the 'Tube'

a summary table for the precipitator. Precip - allows the user to select and enter parameters for the growth method. It also contains a table for Thermal

then the following actions occur: All material in streams connected to the 'Feed' and 'Recycle' inlets will flow straight out of the 'Product' outlet,

actions occur: All material in streams connected to the 'Feed' inlet will flow straight out of the 'Product' outlet; No material will flow out of the 'Vapour'

Navigation: Models ➔ Energy Transfer Models ➔ Direct Contact Heater 2 The Direct Contact Heater is used to transfer energy from a stream containing live steam

recirculation flow changes for the organic loop. For the barren organic tank, flow increase will be added via the makeup blocks and flow decreases will

recycle flow to the heat exchanger. If the user disables the unit, by un-ticking the On tick box, then the following actions occur: All material in streams

recycle flow to the heat exchanger. If the user disables the unit, by un-ticking the On tick box, then the following actions occur: All material in streams

'Tube In' will flow straight out of 'Tube Out' with no change in temperature and no evaporation. All streams connected to 'Shell In' will flow straight out

results. The final temperature of the material from the unit may NOT be the same as the temperature of the material from the EHX sub-model if there are other

operating pressure or temperature) Condense vapour (e.g. condensing shell & tube heater, where user may specify requirement to condense all vapour) Adjust vapour/liquid

recycle flow to the heat exchanger. If the user disables the unit, by un-ticking the On tick box, then the following actions occur: All material in streams

stream is connected then the steam will flow out of this pipe; If no vapour stream is connected then the steam will flow out of the mixture pipe with the liquids;

It can provide estimates of the Duty required to condense an amount of material, or alternatively, determine the amount of condensation for a given duty

The user sets the amount of flow to the heat exchanger, either as a fixed flowrate or as a fraction of the throughput. This flow will then be heated in either

compound of interest can be added to the Links table to keep track of change. To add extra compound to the Links table, go to View - Plant Model - Settings Tab

Navigation: Models ➔ Energy Transfer Models ➔ Direct Contact Heater The Direct Contact Heater is used to transfer energy from a stream containing live steam

switched off. Improved Simple Heater "FeedCalc" calculation to correctly calculate required flow for a greater range of feed flow conditions. Released 2 August

to give estimates of Duty required by evaporating the required amount of material. Only a single component can be evaporated at present, this is set on the