Search results

NOTE: This option is enabled if the "Prompt to save before solve if models added/removed" option is ticked in the General Options - Generals Tab.

specify this sieve series is to use the Q option, with a Q-value of 1.0 Refer to Size Configuration for more detail on sieve series construction. The Alumina3

for each case where multiple options are available. The databases in this folder will be used to build a list of options presented to the user by the utility

Project Configuration for more information on adding models to the configuration file. Insert into Project See Insert Unit for general information on inserting

See Model Selection for more information on adding models to the configuration file. Insert into Project See Insert Unit for general information on inserting

set some general options. TCE tab - This tab allows the user to choose the corresponding OLI Model Configuration unit and set other TCE options. QFeed -

following shows the sequence of events if sub model options are switched on. See next heading for more information. Note: Makeups also apply to the MUD stream

events if sub model options are switched on. See next heading for more information. BatchCentrifuge tab - This first tab contains general information relating

unit and set other TCE options. MU - Optional tab, or multiple tabs if more than 1 Makeup is selected. Only visible if one of more Makeups are enabled in

Model Selection for more information on adding models to the configuration file. Insert into Project Flowsheet See Insert Unit for general information on inserting

Model Selection for more information on adding models to the configuration file. Insert into Project Flowsheet See Insert Unit for general information on inserting

the user specifies more than a single downtime event, then there will be additional tabs: T2, T3, etc. Info tab - Contains general settings for the unit

following shows the sequence of events if sub model options are switched on. See next heading for more information. The default access window consists of

Basefiles folder. Please see SysCAD Installation Instructions for more information. In general, projects will upgrade smoothly between Major Builds with little

will be processed more quickly within SysCAD and hence is preferred to entering TSpline data. Please refer to Entering Spline Data for more information. See

See Model Selection for more information on adding models to the configuration file. Insert into Project See Insert Unit for general information on inserting

generally no need for more than 50 segments and typically 30 to 50 is sufficient for accuracy. There is an option to add damping. In general damping is not required

through one or more heat exchangers. This model allows the user to embed these heat exchangers as part of the model. (This is often more efficient when

See Model Selection for more information on adding models to the configuration file. Insert into Project See Insert Unit for general information on inserting

for each case where multiple options are available. The databases in this folder will be used to build a list of options presented to the user by the utility