Template:TCE Feeder Workflow

The suggested workflow for configuring the model is:

1. Make sure the project contains at least one of the [[{{{TCE}}} Model Configuration]] model, and the model is loaded with the correct {{{TCE}}} database you would like to use for the {{{TCE}}} Feeder.
2. On the [[#{{{TCE}}}Feeder_tab_page|{{{TCE}}}Feeder]] tab page, configure the model - methods, pressures, sub-models (if applicable)
3. On the DInput tab page, specify the composition of the feed. Note: Flow, temperature and pressure can also be specified on this page.
4. On the TCE tab page, select the correct ChemModel (to match step 1) (Note: In older builds, this selection was made on the [[#{{{TCE}}}Feeder_tab_page|{{{TCE}}}Feeder]] tab page).
5. Select other TCE options (Bypass, VLE, CFE, etc.)
6. Choose the Target Calculation OpMode and fill in the required information based on the operation mode selection.
7. Perform an equilibrium calculation by pressing Solve in SysCAD.
8. The Results are displayed in the [[#{{{TCE}}}Results tab page|{{{TCE}}}Results]] and Output tabs.
9. Check and fix any species mapping issues. ({{{TCE}}} resulting species may change if the operating conditions change, so it is likely a change of temperature or feed composition will result in different {{{TCE}}} species.)